Here at DYCO, we will design and build to your specifications or build from your complete print. If you would like to pool engineering resources, then let's work together.

We have extensive experience in the design of various types of transformers and inductors. This includes power, step-up and step-down, control, three-phase, switch-mode power supply, flyback, audio, pulse, current, high voltage, and planar transformers. We design and build inductors, chokes, reactors, common-mode chokes and surface mount inductors.

Our designs utilize a wide variety of materials:

• Windings:Single copper turns stamped or photo-etched, printed circuit board windings, MW80C-155° C magnet wire, MW35C-200° C magnet wire, or any insulation and temperature rated wire an application requires, litz wires, insulated lead wire, copper sheets and foils.
• Laminations: Steel, nickel, cut C-cores, cut-E-cores
• Toroids: Tape wound steel and nickel, MPP, Iron Powder, Hi- Flux, and Cool Mu
• Ferrites: Pot Cores, EFD, EPC, E, PQ cores, EC cores, ETD cores, EP cores, Toroidal and Planar-Low Profile cores, High Frequency Ferrite Beads, Rods, and Slugs
• Insulations: Kapton, Nomex, Mylar, and any other insulating tapes or sheets an application may require. We impregnate, insulate, and/or encapsulate units with a wide range of materials including epoxies and silicones( some highly filled and thermally conductive), urethanes, foams, varnishes, resins, RTVs, and RF lacquers.